Intel® Cyclone® 10 GX FPGA Development Kit User Guide

Download PDF
ID 683696
Date 8/15/2018
Public
Document Table of Contents
Document Table of Contents x
1. Overview 2. Getting Started 3. Development Kit Setup 4. Development Kit Components 5. Board Test System A. Additional Information B. Revision History
1. Overview x
1.1. General Development Kit Description 1.2. Recommended Operating Conditions 1.3. Handling the Board
2. Getting Started x
2.1. Installing the Quartus Prime Software 2.2. Development Kit Package 2.3. Installing the Intel® FPGA Download Cable Driver
3. Development Kit Setup x
3.1. Setting up the Development Kit 3.2. Default Switch and Jumper Settings
4. Development Kit Components x
4.1. Board Overview 4.2. Cyclone 10 GX FPGA 4.3. MAX 10 System Controller 4.4. FPGA Configuration 4.5. Status and User I/O Elements 4.6. Clocks 4.7. Memory 4.8. Power 4.9. Transceivers Interfaces and Communication Ports
4.5. Status and User I/O Elements x
4.5.1. Switches 4.5.2. Pushbuttons 4.5.3. LEDs
4.7. Memory x
4.7.1. EMIF with DDR3 4.7.2. QSPI Flash
4.9. Transceivers Interfaces and Communication Ports x
4.9.1. Transceiver Channels 4.9.2. PCIe Interface 4.9.3. SFP+ Interface 4.9.4. USB3.1 Type-C Interface 4.9.5. FPGA Mezzanine Card (FMC) Interface 4.9.6. 10/100/1000Base-T Ethernet Connector 4.9.7. I2C/PMBUS
5. Board Test System x
5.1. Preparing the Board 5.2. Running the Board Test System 5.3. Using the Board Test System
5.3. Using the Board Test System x
5.3.1. The Configure Menu 5.3.2. The System Info Tab 5.3.3. The GPIO Tab 5.3.4. The EPCQ Tab 5.3.5. The XCVR Tab 5.3.6. The FMC Tab 5.3.7. The DDR3 Tab 5.3.8. Power Monitor 5.3.9. Clock Controller
A. Additional Information x
A.1. Safety and Regulatory Information A.2. Compliance and Conformity Statements
A.1. Safety and Regulatory Information x
A.1.1. Safety Warnings A.1.2. Safety Cautions
B. Revision History x
B.1. Document Revision History for Intel® Cyclone® 10 GX FPGA Development Kit User Guide
1. Overview
2. Getting Started
3. Development Kit Setup
4. Development Kit Components
5. Board Test System
A. Additional Information
B. Revision History

5.3.1. The Configure Menu

Use the Configure Menu to select the design you want to use. Each design example tests different board features. Select a design from this menu and the corresponding tabs become active for testing.

Figure 11. The Configure Menu
To configure the FPGA with a test sustem design, perform the following steps:
  1. On the Configure menu, click the configure command that corresponds to the functionality you wish to test.
  2. In the dialog box that appears, click Configure to download the corresponding design to the FPGA.
  3. When configuration finishes, the design begins running in the FPGA. The corresponding GUI application tabs that interface with the design are now enabled.

If you use the Intel® Quartus® Prime Programmer for configuration, rather than the BTS GUI, you may need to restart the GUI.

Level Two Title