GPIO Intel® FPGA IP User Guide: Intel® Arria® 10 and Intel® Cyclone® 10 GX Devices

Download PDF
ID 683136
Date 9/13/2023
Public
Document Table of Contents
Document Table of Contents x
GPIO Intel® FPGA IP User Guide: Intel® Arria® 10 and Intel® Cyclone® 10 GX Devices
GPIO Intel® FPGA IP User Guide: Intel® Arria® 10 and Intel® Cyclone® 10 GX Devices x
Release Information for GPIO Intel® FPGA IP GPIO Intel® FPGA IP Features GPIO Intel® FPGA IP Data Paths GPIO Intel® FPGA IP Interface Signals Verifying Resource Utilization and Design Performance GPIO Intel® FPGA IP Parameter Settings Register Packing GPIO Intel® FPGA IP Timing GPIO Intel® FPGA IP Design Examples IP Migration Flow for Arria® V, Cyclone® V, and Stratix® V Devices Intel® Arria® 10 and Intel® Cyclone® 10 GX GPIO Intel® FPGA IP User Guide Archives Document Revision History for GPIO Intel® FPGA IP User Guide: Intel® Arria® 10 and Intel® Cyclone® 10 GX Devices
GPIO Intel® FPGA IP Data Paths x
Input Path Output and Output Enable Paths
GPIO Intel® FPGA IP Interface Signals x
Shared Signals Data Bit-Order for Data Interface Input and Output Bus High and Low Bits Data Interface Signals and Corresponding Clocks
GPIO Intel® FPGA IP Timing x
Timing Components Delay Elements Timing Analysis Timing Closure Guidelines
Timing Analysis x
Single Data Rate Input Register Full-Rate or Half-Rate DDIO Input Register Single Data Rate Output Register Full-Rate or Half-Rate DDIO Output Register
GPIO Intel® FPGA IP Design Examples x
GPIO Intel® FPGA IP Synthesizable Intel® Quartus® Prime Design Example GPIO Intel® FPGA IP Simulation Design Example
IP Migration Flow for Arria® V, Cyclone® V, and Stratix® V Devices x
Migrating Your ALTDDIO_IN, ALTDDIO_OUT, ALTDDIO_BIDIR, and ALTIOBUF IP Cores Guideline: Swap datain_h and datain_l Ports in Migrated IP
GPIO Intel® FPGA IP User Guide: Intel® Arria® 10 and Intel® Cyclone® 10 GX Devices

Input Path

The pad sends data to the input buffer, and the input buffer feeds the delay element. After the data goes to the output of the delay element, the programmable bypass multiplexers select the features and paths to use.

Each input path contains two stages of DDIOs, which are full-rate and half-rate.

Figure 2. Simplified View of Single-Ended GPIO Input Path


  1. The pad receives data.
  2. DDIO IN (1) captures data on the rising and falling edges of ck_fr and sends the data, signals (A) and (B) in the following waveform figure, at single data rate.
  3. DDIO IN (2) and DDIO IN (3) halve the data rate.
  4. dout[3:0] presents the data as a half-rate bus.
Figure 3. Input Path Waveform in DDIO Mode with Half-Rate Conversion

In this figure, the data goes from full-rate clock at double data rate to half-rate clock at single data rate. The data rate is divided by four and the bus size is increased by the same ratio. The overall throughput through the GPIO IP remains unchanged.

The actual timing relationship between different signals may vary depending on the specific design, delays, and phases that you choose for the full-rate and half-rate clocks.



Note: The GPIO IP does not support dynamic calibration of bidirectional pins. For applications that require dynamic calibration of bidirectional pins, refer to the related information.
Related Information
Level Two Title