GPIO Intel® FPGA IP User Guide: Intel® Arria® 10 and Intel® Cyclone® 10 GX Devices

Download PDF
ID 683136
Date 9/13/2023
Public
Document Table of Contents
Document Table of Contents x
GPIO Intel® FPGA IP User Guide: Intel® Arria® 10 and Intel® Cyclone® 10 GX Devices
GPIO Intel® FPGA IP User Guide: Intel® Arria® 10 and Intel® Cyclone® 10 GX Devices x
Release Information for GPIO Intel® FPGA IP GPIO Intel® FPGA IP Features GPIO Intel® FPGA IP Data Paths GPIO Intel® FPGA IP Interface Signals Verifying Resource Utilization and Design Performance GPIO Intel® FPGA IP Parameter Settings Register Packing GPIO Intel® FPGA IP Timing GPIO Intel® FPGA IP Design Examples IP Migration Flow for Arria® V, Cyclone® V, and Stratix® V Devices Intel® Arria® 10 and Intel® Cyclone® 10 GX GPIO Intel® FPGA IP User Guide Archives Document Revision History for GPIO Intel® FPGA IP User Guide: Intel® Arria® 10 and Intel® Cyclone® 10 GX Devices
GPIO Intel® FPGA IP Data Paths x
Input Path Output and Output Enable Paths
GPIO Intel® FPGA IP Interface Signals x
Shared Signals Data Bit-Order for Data Interface Input and Output Bus High and Low Bits Data Interface Signals and Corresponding Clocks
GPIO Intel® FPGA IP Timing x
Timing Components Delay Elements Timing Analysis Timing Closure Guidelines
Timing Analysis x
Single Data Rate Input Register Full-Rate or Half-Rate DDIO Input Register Single Data Rate Output Register Full-Rate or Half-Rate DDIO Output Register
GPIO Intel® FPGA IP Design Examples x
GPIO Intel® FPGA IP Synthesizable Intel® Quartus® Prime Design Example GPIO Intel® FPGA IP Simulation Design Example
IP Migration Flow for Arria® V, Cyclone® V, and Stratix® V Devices x
Migrating Your ALTDDIO_IN, ALTDDIO_OUT, ALTDDIO_BIDIR, and ALTIOBUF IP Cores Guideline: Swap datain_h and datain_l Ports in Migrated IP
GPIO Intel® FPGA IP User Guide: Intel® Arria® 10 and Intel® Cyclone® 10 GX Devices

Guideline: Swap datain_h and datain_l Ports in Migrated IP

When you migrate your GPIO IP from previous devices to the GPIO IP, you can turn on Use legacy top-level port names option in the GPIO IP parameter editor. However, the behavior of these ports in the GPIO IP is different than in the IP used for the Stratix® V, Arria® V, and Cyclone® V devices.

The GPIO IP drives these ports to the output registers on these clock edges:

  • datain_h—on the falling edge of outclock
  • datain_l—on the rising edge of outclock

If you migrated your GPIO IP from Stratix® V, Arria® V, and Cyclone® V devices, swap the datain_h and datain_l ports when you instantiate the IP generated by the GPIO IP.

Related Information
Level Two Title