Ethernet Toolkit User Guide

Download PDF
ID 683793
Date 4/01/2024
Public
Document Table of Contents
Document Table of Contents x
1. Ethernet Toolkit Overview 2. Setting up the Ethernet Toolkit 3. Functional Description 4. Document Revision History for the Ethernet Toolkit User Guide
1. Ethernet Toolkit Overview x
1.1. Features 1.2. Supported Ethernet IP Cores and Devices
2. Setting up the Ethernet Toolkit x
2.1. System Requirements and Prerequisites 2.2. Running the Ethernet Toolkit
2.1. System Requirements and Prerequisites x
2.1.1. System Requirements 2.1.2. Enabling your Design for the Ethernet Toolkit
3. Functional Description x
3.1. Ethernet Toolkit Groups and Tabs 3.2. Link Bring Up Guidelines 3.3. Ethernet Toolkit Multirate Support 3.4. Ethernet Toolkit Subsystem Support 3.5. Ethernet Toolkit GTS Ethernet Hard IP Support
3.1. Ethernet Toolkit Groups and Tabs x
3.1.1. IP Configuration and Other Information 3.1.2. General Commands 3.1.3. Settings 3.1.4. Status 3.1.5. Statistics Counters 3.1.6. Testing Features
3.1.2. General Commands x
3.1.2.1. Loopback 3.1.2.2. Resets
3.1.4. Status x
3.1.4.1. Link Bring Up 3.1.4.2. PCS Status 3.1.4.3. PHY Status 3.1.4.4. MAC Settings 3.1.4.5. AN and LT Status
3.1.5. Statistics Counters x
3.1.5.1. Example Design Packet Generator Settings 3.1.5.2. Transmitter and Receiver Statistics 3.1.5.3. RS-FEC
3.1.5.1. Example Design Packet Generator Settings x
3.1.5.1.1. Packet Generator for E-, H-, and L-Tile Ethernet IPs 3.1.5.1.2. Packet Generator for F-Tile Ethernet IP
3.1.5.2. Transmitter and Receiver Statistics x
3.1.5.2.1. Effective Bandwidth Calculation
3.1.5.3. RS-FEC x
3.1.5.3.1. 32-Bit Soft CWBIN Counter Status
3.1.6. Testing Features x
3.1.6.1. Example Design PHY and Packet Generator Loopback Test 3.1.6.2. Read Register 3.1.6.3. Write to Register
3.2. Link Bring Up Guidelines x
3.2.1. Example Link Bring Up Using E-Tile Hard IP 3.2.2. Example Link Bring Up Using F-Tile Hard IP 3.2.3. Example Link Bring Up Using GTS Ethernet Hard IP
1. Ethernet Toolkit Overview
2. Setting up the Ethernet Toolkit
3. Functional Description
4. Document Revision History for the Ethernet Toolkit User Guide

3.1.5.1. Example Design Packet Generator Settings

You can access Example Design Packet Generator Settings tab only if you are using an Quartus® Prime generated design example. You can start and stop the packet generator using the options from the tab. You can also set the source and destination address using this tab.


Section Content
Packet Generator for E-, H-, and L-Tile Ethernet IPs
Packet Generator for F-Tile Ethernet IP

Level Two Title