AN 954: Hierarchical Partial Reconfiguration Tutorial: for the Intel® Agilex® F-Series FPGA Development Board

ID 683687
Date 8/04/2021
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Step 10: Programming the Board

This tutorial uses an Intel® Agilex® F-Series FPGA development board on the bench, outside of the PCIe* slot in your host machine. Before you program the board, ensure that you have completed the following steps:

  1. Connect the power supply to the Intel® Agilex® F-Series FPGA development board.
  2. Connect the Intel® FPGA Download Cable between your PC USB port and the Intel® FPGA Download Cable port on the development board.

To run the design on the Intel® Agilex® F-Series FPGA development board:

  1. Open the Intel® Quartus® Prime software and click Tools > Programmer.
  2. In the Programmer, click Hardware Setup and select USB-Blaster.
  3. Click Auto Detect and select the appropriate device for your development kit.
  4. Click OK. The Intel® Quartus® Prime software detects and updates the Programmer with the three FPGA chips on the board.
  5. Select the Intel® Agilex® device, click Change File and load the blinking_led.sof file.
  6. Enable Program/Configure for blinking_led.sof file.
  7. Click Start and wait for the progress bar to reach 100%.
  8. Observe the LEDs on the board blinking at the same frequency as the original flat design.
  9. To program only the child PR region, right-click the blinking_led.sof file in the Programmer and click Add PR Programming File.
  10. Select the hpr_child_slow.pr_parent_partition.pr_partition.rbf file.
  11. Disable Program/Configure for blinking_led.sof file.
  12. Enable Program/Configure for hpr_child_slow.pr_parent_partition.pr_partition.rbf file and click Start. On the board, observe LED[0] and LED[1] continuing to blink. When the progress bar reaches 100%, LED[2] blinks at the same rate, and LED[3] blinks slower.
  13. To program both the parent and child PR region, right-click the .rbf file in the Programmer and click Change PR Programing File.
  14. Select the hpr_parent_slow_child_slow.pr_parent_partition.rbf file.
  15. Click Start. On the board, observe that LED[0] and LED[1] continuing to blink. When the progress bar reaches 100%, both LED[2] and LED[3] blink slower.
  16. Repeat the above steps to dynamically re-program just the child PR region, or both the parent and child PR regions simultaneously.
Figure 14. Programming the Intel® Agilex® F-Series FPGA Development Board

If you face any PR programming errors, refer to the Avoiding PR Programming Errors section in the Partial Reconfiguration User Guide.