Article ID: 000083085 Content Type: Troubleshooting Last Reviewed: 03/26/2018

Why does the generated Intel® Stratix® 10 100G Ethernet soft IP with RS-FEC example design fail to complete simulation?

Environment

  • Intel® Quartus® Prime Pro Edition
  • Low Latency 100G Ethernet Intel® FPGA IP for Arria® 10 and Stratix® V
  • BUILT IN - ARTICLE INTRO SECOND COMPONENT
    Description

    Due to a problem in the simulation testbench of the example design generated by the Intel® Quartus® Prime Pro software version 17.1.1, the simulation fails to complete.  You will see the simulation hang at packet 10 as shown below.

     

    ***************************************************

    **************   Recieve Ready   ******************

    ***************************************************

    Transmitting test data

    ** Sending Packet           1...

    ** Sending Packet           2...

    ** Sending Packet           3...

    ** Sending Packet           4...

    ** Sending Packet           5...

    ** Sending Packet           6...

    ** Sending Packet           7...

    ** Sending Packet           8...

    ** Sending Packet           9...

    ** Sending Packet          10...

    Resolution

    To work around this problem, replace the original generated testbench <your example project>/example_testbench/basic_avl_tb_top.v with this new testbench.

    This problem is scheduled to be fixed in a future version of the Intel® Quartus® Prime Pro software.

    Related Products

    This article applies to 1 products

    Intel® Stratix® 10 FPGAs and SoC FPGAs