Article ID: 000082272 Content Type: Troubleshooting Last Reviewed: 09/11/2012

Why do I get error message when I change IO termination value with UniPHY memory controller ?

Environment

BUILT IN - ARTICLE INTRO SECOND COMPONENT
Description

UniPHY based IP has only one OCT controller block, thus changing the OCT termination value from 50 Ohm to 25 Ohm for a specific signal will generate the following error message:

Error (174043): I/O "pin_name" is driven by on-chip termination control block "{hierarchy_path}:uoct_control|sd1a_0" but has a termination value which conflicts with other I/Os driven by that control block.

Resolution

 

Related Products

This article applies to 1 products

Stratix® IV E FPGA